Table of Contents
Advertisement
PACE Pressure Indicators User Manual
Communication Connections
Connect the applicable connectors into the rear panel communications ports and, if appropriate,
secure with the captive screws.
Note: The RS232 and IEEE 488 interfaces are both enabled at power-up. Set the required parameters
in Supervisor Setup/communications menu, see Section 3.6.
1
Power supply adaptor
1
USB B
5
RS232 Interface
When using the RS232 interface, a cable must be connected directly from the instrument to a
suitable port on the computer in a 'point to point' link.
The pin connections for the 9-pin D-type, RS232 connector and the relationship between the
instrument and the RS232 control signals, together with device interconnection interface is shown
in Table 2-1. The instrument is configured as Data Circuit Terminating Equipment (DCE).
[EN] English
CONSULT HANDBOOK
ANALOGUE 1
22V to 26V
2
4
Figure 2-7, Communication Connectors
2
RS232
6
USB A
5
6
7
Ethernet
2 - 11
7
4 IEEE488
K0470 Revision A
Advertisement
Table of Contents
