Table of Contents
Advertisement
PACE Pressure Indicators User Manual
8
Secure the instrument in the equipment rack with two of the screws and washers
(supplied).
9.
Remove the two spigots* and replace with the remaining two screws and washers
(supplied).
Panel-mount option (Figure 2-6)
There must be enough space at the rear of the instrument for all the cables and pipes.
The length of the cables and pipes must allow for the removal and fitment of the instrument.
The cooling air of the instrument must not be obstructed.
Allow a free flow of air through the equipment rack and around the instrument, especially at high
ambient temperatures.
Procedure
1.
Remove the four screws
2.
Locate the instrument in panel mount assembly.
3.
Secure with the four screws
4.
Support the instrument and connect the cables and pipes.
5.
Refer to the electrical connections below before fitting the instrument into the panel.
6.
Secure the instrument in the panel with four screws and washers
[EN] English
Figure 2-6 Panel-mounting
from the instrument.
.
2 - 9
.
K0470 Revision A
Advertisement
Table of Contents
