Vanishing Act Instructions - HotSpring LIMELIGHT Prism Owner's Manual

PRISM
Instructions for Use:
1. After Filling your hot tub, use a test strip to measure the
hardness level of the water. If hardness is above 100 ppm,
use the VANISHING ACT calcium remover to soften the water.
Suggested Hardness Level: between 75 - 150 ppm, (it must
be between 25 - 75 ppm when using the FRESHWATER Salt
System in order to work).
2. Rinse the VANISHING ACT calcium remover with running water
until water runs clear. When placed in the hot tub, slight color
transfer to the water may occur and can be easily resolved with
chlorine.
3. Locate your spa above to determine which jet suction fitting the
VANISHING ACT calcium remover will be placed up over. Use
the circle to determine location.
a. Press OPTIONS hard button on the Control panel.,
• Press the soft button next to Set-Up.
Press the soft button next to More.
•
• Press the soft button next to VANISHING ACT to start low speed
jet pump for 6 hours.
• Place the VANISHING ACT calcium remover firmly against
the associated jet suction fitting.
Water Quality and Maintenance

VANISHING ACT INSTRUCTIONS

FLASH
Page 11
PULSE
BEAM
b. Test the spa water for hardness after jets shut off, which will take
around 6 hours.
IMPORTANT:
• Always make sure water is balanced and properly sanitized,
using the EPA approved sanitizer, before entering your hot
tub.
• For maximum effectiveness, ensure that the calcium
remover remains on the suction fitting while the calcium
remover is in use.
• Calcium remover may not be necessary if water hardness is
already in or below the suggested range.
• Multiple calcium removers maybe needed if initial water
hardness is above 200 ppm.
FLAIR