Removing The Engine - 990 Adventure - KTM 990 Adventure Repair Manual

2
1
3
3
5
5
6
6
5 5
9
8
bk

Removing the engine - 990 Adventure

– Screw the center stand 600.03.022.000 onto the frame
up the motorcycle on a firm, even surface.
– Remove the left bump rubber and lock the center stand with the
lock 600.29.055.000
NOTE: if available, use the center stand already on the bike.
– Unlock the seat lock with the ignition key and remove.
1
– Remove the bolts
disconnect the front turn signal, pull the tank vent hoses off of the
fuel tank and remove the side covers.
– Open the tank cover, unscrew the fixing bolts
4
upper tank compartment.
4
– Remove the bolts
box, take the cover off the fuse box and dismount the lower tank
compartment.
– Close the fuel cocks, disconnect the tank line, unscrew the upper
and lower
together with the lower vent hoses.
– Drain the engine oil from the oil tank and the engine: see Chapter 12.
7
– Remove the 4 bolts
underride protection.
– Remove both bolts
8
– Open the lid on the battery compartment and disconnect the battery
terminals
– Take out the battery and remove the upper battery cover.
bk
.
2
on the left and right of the front side covers,
3
on the lower tank compartment and the fuse
5
fixing bolts on both fuel tanks and remove the tanks
7
on the underride protection and take off the
8
on the front cover and take off the cover.
9
(starting with the negative pole).
bk
3-12
and jack
1
and remove the
4
6