Mounting The Engine - 990 Super Duke - KTM 990 Adventure Repair Manual

3-25
1
2
3
4
6
7

Mounting the engine - 990 Super Duke

– Connect the water, SLS and vacuum hoses to the engine before
– Position the exhaust system under the motorcycle according to the
– Position the swing arm and hold in place with the swing arm bolt on
– Lift the engine into the frame with a floor jack, insert the sealing
– Run the chain along the side of the pinion and push the swing arm
– Insert the bolt
– Remove the floor jack attachment 600.29.055.100 from the
– Connect the connectors for the oil pressure switch
5
– Screw on the ground cable terminal
– Insert the short manifold pipe into the exhaust with a new gasket.
– Position the front and rear exhaust manifold on the cylinder head
8
mounting (Öttiger clamps - special pliers 600.29.057.000 or
spring-loaded band-type clamps - special pliers 600.29.057.100).
installation position.
the right and a suitable pipe on the left.
washer in the rear exhaust flange and, if necessary, secure with a
small amount of copper paste.
bolt through the chain, screw on the nut but do not tighten yet.
1
for the lower support through the chain (raise or
2
lower the engine if necessary).
engine.
temperature sensor and the front
4
the wiring harnesses with cable clips.
and slightly tighten the nuts
and rear ignition coil. Secure
5
.
6
and ; do not screw tight.
7 8
, the
3