Refitting The Engine - 990 Supermoto - KTM 990 Adventure Repair Manual

2
3
5
6

Refitting the engine - 990 Supermoto

– Before mounting the engine, attach the water, SLS and vacuum
hoses (Öttiger clamps - special pliers 600.29.057.000 or spring-
loaded band-type clamps - special pliers 600.29.057.100)
– Position the swing arm and fix with the swing arm pivot on the right
and a suitable pipe on the
– Lift the engine into the frame with the trolley jack, insert the sealing
washer in the rear exhaust flange and secure with copper paste if
necessary.
– Guide the chain along the side of the pinion and insert the swing
arm pivot
– Insert the bolt in the lower support (raise or lower the engine slightly
if necessary).
– Remove the trolley jack attachment 600.29.055.100 from the
engine.
1
– Plug the connector on the oil pressure switch
sensor
fasten the wiring harnesses.
4
– Screw the ground cable connections
the starter.
5
– Place the chain over the pinion and rear sprocket.
– Tension the chain using the chain adjuster
manual.
– Tighten the nut on the wheel spindle to 90 Nm.
6
left..
, screw on the nut but do not tighten yet.
1
and the front and rear ignition coil
3
3-40
, the temperature
2
. Use cable clips to
4
and the positive cable onto
5
, see the owner's
6