Casing
=
Servicing and fault indicator (red LED)
%
Battery release button
&
Battery
(
Control switch
)
Tubular guard for adjusting (shorten-
+
ing/extending) the stroke
3.2
Intended use
The product described is a cordless electro-hydraulic crimping tool.
It is designed for crimping fittings used to connect composite, copper (Cu) and steel pipes.
▶ Use only Hilti lithiumion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3
Possible misuse
•
Do not use this hand-held product clamped in a fixed position or as a stationary device.
•
This electro-hydraulic crimping tool may not be exposed to heavy rain or used under water.
3.4
Lithiumion battery status display
The charge state of the Li-ion battery and malfunctions of the product are indicated by the indicator of the
Liion battery. The state of charge of the Liion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED flashes.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the LEDs of the charge state indicator flash, follow the instructions
in the 'Troubleshooting' section.
3.5
Items supplied
Crimping / pressing tool, operating instructions.
Other system products approved for use with this product can be found at your local HILTI STORE or online
at: www.hilti.group
4
Technical data
Rated voltage
Weight in accordance with EPTA procedure 01
Crimping / pressing time
Max. crimping / pressing force
Storage temperature
Ambient temperature for operation
4.1
Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
Printed: 29.10.2018 | Doc-Nr: PUB / 5436899 / 000 / 01
Locking pin for opening/closing the tool
§
head
Crimping jaw holder
/
Pressing ring with adapter jaws
:
White LED to illuminate the working area
∙
Manual piston return switch
$
Meaning
•
State of charge: 75 % to 100 %
•
State of charge: 50 % to 75 %
•
State of charge: 25 % to 50 %
•
State of charge: 10 % to 25 %
•
State of charge: < 10 %
NPR 032 PE-A22
21.6 V
4.58 kg
≈ 7 s
32 kN
−20 ℃ ...70 ℃
−17 ℃ ...60 ℃
English
7