The Crimping / Pressing Tool Is In Working Order; Disposal; Rohs (Restriction Of Hazardous Substances); Manufacturer's Warranty - Hilti NPR 032 PE-A22 Operating Instructions Manual

8.2

The crimping / pressing tool is in working order

Trouble or fault
The battery runs down more
quickly than usual.
The battery does not engage
with an audible double click.
Red LED => flashes at long
intervals and a warning tone
is emitted.
Red LED => lights continu-
ously and a warning tone is
emitted.
Red LED => lights continu-
ously and no warning tone is
emitted.
9

Disposal

Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10

RoHS (Restriction of Hazardous Substances)

Click on the link to go to the table of hazardous substances: qr.hilti.com/r8824330.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 29.10.2018 | Doc-Nr: PUB / 5436899 / 000 / 01
Possible cause
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
Crimping / pressing pressure not
achieved (tool was used incor-
rectly).
Technical problem.
Product maintenance necessary.
Action to be taken
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lugs and refit
the battery.
▶ Make sure that the tool is used
correctly and check the crimped
/ pressed part if unsure.
▶ Incorrect operation is possible!
Contact Hilti Service.
▶ Contact Hilti Service.
English 15