First Ignition - eka EKF 711G UD Original Operating And Instruction Manual

Convection gas oven _ rev. 2__________________________ MODD. EKF 711G UD – EKF 664G UD – EKF 616G UD
Warning lights
Programmer warning light
"end of cooking"
"no Gas" warning light
"Reset" button
"End of cooking" programmer warning light
It indicates that the oven is working and that cooking time may be active.
Adjustment thermostat warning light
It switches off each time the set temperature is reached in the cooking chamber. It switches on
again when the thermostat is triggered to re-establish this temperature.
Automatic humidifier warning light
It indicates the water solenoid valve is active, hence humidity/steam is being produced in the
cooking chamber.
Indicator light "no gas "
When the "No Gas" indicator lights red, it means that oven gets the " thermal block ", that is
the burner fails to start. It lights up whenever , during the starting of the oven or during
operation , the regular flow of gas to the burner fails ( no flame )
"Reset" button
For the " thermal release " of the oven , simply press the "Reset" button located in the
direction of the pilot light "No Gas". The ignition of the burner is automatically repeated. The
"Reset" button must be pressed after at least 5/6 seconds after "No Gas" lights on.
Warning
At first ignition of the burner of the oven, for possible presence of air in the pipeline that feeds
the device, it may be necessary to repeat the operation of "thermal release" of the oven (press
several times the button "reset").

4.3 First ignition

The oven can be used for the first time only after the chamber has been carefully cleaned with a
special detergent for stainless steel. The detergent must not contain acid substances (chloride
acid, bleach, etc.) or be abrasive. Alternatively the chamber can be washed with warm soapy
water or warm water and a drop of vinegar. Rinse well and dry with a soft cloth.
First ignition (without food inside the oven) serves to eliminate any unpleasant smells (which are
quite normal) due to the thermal insulation heating up that covers the cooking chamber and
any oil residues from assembly of the metal parts.
After turning the power on (close the unipolar switch fitted upstream from the appliance), the
gas supply (open the interception cut-off tap), and the water (open the interception cut-off tap),
proceed as follows:
_________________________________________________________________________________________ page. 17
Adjustment thermostat
warning light
Automatic humidifier
warning light
(for ovens providing this option)