Storage - eka EKF 711G UD Original Operating And Instruction Manual

Convection gas oven _ rev. 2__________________________ MODD. EKF 711G UD – EKF 664G UD – EKF 616G UD

2.1 Storage

If the appliance has been stored in a warehouse at a temperature below 0°C (min. allowed is –
5°C), it should be brought to a temperature of at least +10°C before it is turned on.
2.2 Transporting the oven
During transport, the appliance must be left in its original wooden cage to protect it against
damage.
2.3 Unpacking the oven
Remove all the packaging before installation, which is formed of a wooden pallet that holds the
appliance and cardboard casing to protect it. Check that the appliance has not been damaged
during transport and if any damage is discovered immediately inform your retailer and/or the
haulier.
2.4 Removing the protective film
Before using the appliance, carefully remove the special protective film over the stainless steel
parts, without leaving any glue residue on the surfaces. If necessary, remove the residue at once
with a suitable non-inflammable solvent (e.g. acetone).
2.5 Disposing of the packaging
The packaging must be disposed of in accordance with current legislation in force in the place
where the appliance is installed. The various types of materials (wood – paper – cardboard –
nylon – metal staples) used for the packaging must be separated and delivered to the specific
waste disposal centres. In all circumstances the environmental protection regulations must be
strictly adhered to.
2.6 Positioning
Check the place where the appliance will be installed to ensure that the passages (doors and
corridors) are wide enough (the appliance measurements are given in Fig. 3).
The appliance must be installed in a well ventilated room with permanent ventilation openings –
if possible, it should be placed under an exhaustion hood ensuring complete evacuation of
burned gasses produced during baking. Locate the oven on a table or similar support. We
advise to use the support given by the manufacturer; otherwise you must consider the weight
of the oven. Never on the floor.
The maximum working height, referred to the highest surface level, must be 1.6 meters from
the floor. After installing the appliance apply the suitable adhesive symbol at a height of 1.6
meters.
For easier access and to allow the air to circulate freely around the appliance, leave at least 50
cm between the left side and the wall (or other appliances), and at least 10 cm between the
back and the wall and the right side and the wall (see Fig. 3). The natural ventilation that is
needed to ensure efficient working for the oven is through the openings on the walls of the
outer covering (left side and back). Consequently, it is strictly forbidden to obstruct these
aeration openings, even partially and even for short periods. Failure to observe this specific
prohibition, shall release the manufacturer from all liability for the appliance and shall
immediately cancel any guarantee rights for the said appliance, because its constructive
conformity has been voluntarily compromised.
For the same reason, do not position equipment with a source of heat on the left hand side of
the oven; in fact if ambient temperature on that side becomes too high, the oven switches itself
off for safety reasons
If the appliance is installed near walls, tops, shelves or other similar items, they must not be
inflammable or sensitive to heat, otherwise they must be protected by a suitable fireproof
covering.
In all cases, all fire prevention standards must be strictly adhered to.
With regards to the methods of discharging combustion fumes and in compliance with the
provisions of the local legislation for the installation of gas equipment, this oven can be
classified and therefore installed as follows:
_________________________________________________________________________________________ page. 9