Troubleshooting - Kaba 7104 series Installation Instructions Manual

Troubleshooting

12
Lock fails to open when combination
?
is entered and outside thumbturn is
rotated clockwise.
Buttons were not fully depressed when
the combination was entered.
Lock not cleared of previous attempts
to enter access codes. Turn outside
thumbturn to the left to clear the wrong
entry. Enter the combination making
sure you feel each button click to know it
was depressed fully.
Turning outside thumbturn clockwise
?
always retracts latch without depressing
any buttons.
Lock is in zero combination.
Follow the procedure for changing
a combination (Section 10, Steps 3-7,
on pages 22 & 23).
? Inside thumbturn only retracts latch
partially or not at all, in either clockwise
or counterclockwise direction.
Latch has not been properly installed.
Take the lock off of the door.
Re-install the latch. Review and follow
instructions in Section 7, Steps 1-5
on pages 16 & 17.
?
After inserting the new combination,
the lock works one time only,
then fails to open.
Buttons of intended combination are not
fully depressed when changing combination.
This is a lost combination situation.
Please call our Technical Service Dept.
For further information at (800) 849-TECH.
Outside U.S.A. and Canada, please call
your KABA ILCO dealer.
Adjustable latch will not retract fully in
?
⁄
3
the 2 " back set position.
4
1" diameter hole is not bored to depth
of at least 4".
Re-drill hole to 4" depth minimum.
15