Generation E-760 Installation Instructions
for Auto Deadbolt, Office and Storeroom
STEPS FOR AUTO DEADBOLT ASM • MODELS 76016 & 76017
M
4
M
2
M
1
M
3
(TOP)
RH
LH
S
F
G
S
X
If not already installed at the factory, put the
thumbturn in the vertical position and install all four
(4)parts (M) as shown, on the inside trim assembly.
Install clip
M1diagonally
on hub
Turn the thumbturn all the way to the right for a RH
installation (arrow onM2points UP), or all the way
to the left for a LH installation (arrow onM2points
DOWN). The thumbturn should stop in the vertical
position, and the stopper cam (M2) will be in the posi-
tion illustrated.
Place 3 spacers (S) on the door (for recent models
only). Place the inside trim assembly on the door so
that the upper and lower spindles (F) and (G) engage
the thumbturn and the inside lever. Fasten to the
RH/LHR
LH/RHR
outside housing using the three 1/8" hex head
mounting screws (I).
Apply the privacy thumbturn sticker as shown. If
in doubt as to the direction of the arrow, press the
I
auxiliary latch (X) to extend the deadbolt, and verify in
which direction to rotate the thumbturn to reach the
horizontal (privacy) position.
I