Kaba 7104 series Installation Instructions Manual page 14

9) If, without entering the combination, you
can retract the latch by turning the outside
thumbturn to the right, it means that a step
was done out of order and therefore no
combination was entered. In this case, you
must repeat Steps 1 to 7 but omit Step 2,
as the lock does not have a combination.
10) Test the lock 2-3 times using the
new combinations to ensure
trouble-free operation.
Making the Latch Face
Plate Cutout
This procedure is applicable to wood doors.
1) Insert the latch into the 1" (25 mm) hole
until the face plate butts up against the
door edge. Draw a line around the face
plate, figure 5-1, A. Remove the latch
from the door.
2) For doors without a beveled edge,
use a sharp 1" (25 mm) wood chisel to
remove approximately
material or enough so the face plate is
perfectly flush with the edge of the door,
figure 5-1, B.
3) For doors with a beveled edge, follow
Step 2 except the face plate will not be
flush with the edge of the door, but rather
square to the face of the door. In order to
accomplish this, you must remove more
wood from the higher edge of the door.
14
⁄
1
" (3 mm) of
8