Kaba 7104 series Installation Instructions Manual page 13

Gently turn to the right (clockwise)
⁄
1
approximately " (3 mm), figure 11-1.
8
A slight click should be felt. Do not force.
IMPORTANT: When removing the screwdriver,
the central piece must return to its initial
position, if not, set it back to its original
position using the screwdriver; see Section 8.
Verify the Combination Change Assembly.
4) Turn the outside thumbturn to the left
(counterclockwise) to the stop position,
once only, to clear the existing code from
the mechanism, then release it.
5) Select a new code and write it down
(some or all of the buttons may be used
for your new code, pressed individually
or simultaneously).
NOTE: Each button may be used only once.
6) With the door open, enter your new code.
Depress each button fully and release.
7) Turn the outside thumbturn to the right
(A) (clockwise) to the stop position. The
latch should retract. Now release the
thumbturn. Try to turn the thumbturn to
the right (clockwise). The thumbturn will
not turn to the right (clockwise) unless the
correct combination is entered. If it does
turn and retracts the latch, see Step 9.
NOTE: Excessive force will result in slipping
the thumbturn 180˚ degrees. The slipping
mechanism, or force-proof clutch, protects the
lock's internal mechanism from forced entry.
8) If a wrong combination is entered after the
desired combination has been programmed
into the lock, turn the outside thumbturn to
the left (B) (counterclockwise) to the stop
position and release, figure 11-2.
This will clear any previously depressed
buttons. Enter the correct new combina
tion. Turn the thumbturn to the right (A)
(clockwise) to the stop position and
release, figure 11-2. The thumbturn
should rotate. The latch will be retracted
flush with the face plate. The correct
combination must be entered each time
you want to unlock the door.
11-1.
A
B
11-2.
13