Generation I Upgrade Instructions - LegUp LandinGear Generation II Installation Manual

GENERATION I UPGRADE INSTRUCTIONS

NOTE: Read this before starting your installation if this is an upgrade!
If you are upgrading from a Generation 1 system, most all the instructions in this manual
pertain to you, but some do not! The most important thing is to NOT take your wiring harness
off the bike! We should have supplied you with an upgrade harness that will allow you to keep
most everything as it was, and adapt the wiring to the new system. The second VERY
important thing is that your computer MUST be sent in for upgrading or it will not work with
the new Generation II system! With those facts in hand, let's get to it!
We will assume you have already removed all your Gen I hardware. The legs, the actuator
mounts, the mounting plate. All you should have left from the old system is the wiring harness.
area to get connected to the battery. You can tie this up to the existing harness wires along the
route back to the battery.
These are only suggestions; run the wires anyway you like; your existing connections to power
will remain as they are. One caveat is that the plug that used to run to the actuator will have no
plug in it. This should not be a problem assuming it is stored in an area that does not get very
wet.
When reading the install manual, you should be able to ignore most all instructions having to do
with wiring and you will NOT need to do the proximity test by rolling the bike, as this should
remain mounted.
If you have any trouble with this upgrade, please give us a call at 407-834-5007.
The upgrade harness plugs into
where the old computer plugged
in. This is a 12 pin plug on the
opposite end of the upgrade
harness from the two plugs that
are close together.
Once this is plugged in, we like to
run the wire with the two plugs
along the bottom of the bag, back
to the compressor.
The thin wire with the fuse holder
on it gets run back toward the seat
39