Leg & Mount Assemblies - LegUp LandinGear Generation II Installation Manual

LEG & MOUNT ASSEMBLIES
This manual covers our Rev B Mounting system, which replaces
IMPORTANT!
the stock passenger single bolt design with our own, two bolt mounts. If you have
the earlier mounting system that clamps to existing floorboards, please see the
link below for the correct manual for your application:
http://landingear.com/pdf/g2installhdfl.pdf
First we want to remove the passenger floorboards (if installed). If your bike had pegs, you can
buy floorboards from Harley or we can supply them to you (skip to the next page!). If you have
floorboards, it is easier to remove
these while the mount is still on
the bike!
As shown at right, lift the inboard
part of the floorboard cover,
which exposes (2) pins, and soon
a ball-bearing and a spring. The
arrow shows Ben pushing one of
the pins toward the center. Do this
on both sides, but keep pressure
downward on the board to
maintain the ball-bearing and
spring that is beneath it in the
middle. Once this is done,
carefully raise the board off the
mount, catching said spring setup, and set the board & hardware aside for installation later.
In order to mount the legs in place of the passenger floorboards/pegs, we must remove the
existing rear floorboard or pegs mounts, whichever the bike is using. Depending on the year,
the bike will have one or two Allen bolts holding the now exposed mount to the bike. Once
rd
these are removed, make sure the top and the 3 hole from the top do NOT have any plastic
plugs in them.
We are now ready to mount the Legs.
13