LegUp LandinGear Generation II Installation Manual page 23

Now attach the bag to the bike. NOTE: Once the system is operational, in order to remove the
bag, you will make sure the wheels are up, pull the ring on the safety valve of the tank to let
the air out, tilt the compressor forward to disconnect the plugs, and remove the rear bail nut,
then disconnect the hoses at the white connectors and remove the bag!
Run the wire with the two plugs into the bag all the way toward the back; just behind the end of
the rubber gasket. Find the computer and plug it into the big plug, then plug the small plug into
the plug from the compressor (you will likely need to tilt the compressor forward to get to the
We need to find the inline connectors
(white in this picture, could be a
different color) and attach them to the
end of the lines you ran toward the back
of the saddlebag.
Next, put the bag on the support rail,
tilted out toward you as shown here.
Attach the two small lines to the
connectors from above. Give a tug to
make sure they are snug. At this point,
it is helpful to push the extra small line
back into the bag. Again, make sure the
connections are tight!
plug under the cover), guide the wires neatly
so as seen at left.
In preparation for testing the system, if you
haven't already, hook the negative battery
terminal and the lead from our power
connection, up to the negative battery
terminal. On to Initial Testing (don't worry
that the proximity sensor is still lying on the
lift!).
23