Final Adjustments & Maintenance Mode; Maintenance Mode - LegUp LandinGear Generation II Installation Manual

FINAL ADJUSTMENTS & MAINTENANCE MODE
The next two sections are typically NOT needed. We include them to document your system
thoroughly, but MOST people will never need to use either section.

MAINTENANCE MODE

NOTE: Maintenance mode is a procedure that 'TEACHES' the computer how
much pressure to use when it lowers the wheels and how much pressure to
release when raising the wheels. We always set this at the factory; ALWAYS!! We
include this procedure in case it is ever needed in the future. Please skip this
section unless you have been instructed to reset the system by Chopper Design.
Turn the ignition to Accessory and start the LegUp System (hold right button for 3 seconds).
The system should be set at the factory for proper pressure, but some wheel adjustment may be
needed. If it has been determined that 'Maintenance Mode' is needed, Sit on the bike, and hold
it level. If both lights on the switch box are flashing, the system is in maintenance mode. If not,
PRESS & HOLD both buttons until all lights flash. (Do your best to press both buttons at the
same time so the system doesn't respond to what it thinks is a request to lower the legs) Once
flashing, hit both buttons for an instant to get the system in the 'DOWN' setting mode (lower,
yellow LED flashing). Touch the left button briefly; the wheels should go down immediately.
(This is VERY quick, don't be startled!) Using very short pushes of the left button, press and
then feel the stability of the bike. If it feels firm enough, try leaning the bike a bit. If the wheels
return the bike to upright, there is likely enough pressure. Put your feet on the floorboards; the
bike should stand on its' own. Rock the bike a bit left and right, being prepared to put your feet
down. If the bike continues to come back to upright, the DOWN stop is now set and we can
move on.
Hit both buttons for a moment to get into the 'UP' stop mode (Usually hitting the left button
just before the right assures that air is not released!) The top LED should now be blinking.
Press and hold the right button to raise the legs. Listen as the air evacuates; once it is quiet, let
go of the right button. The UP stop is now set! Hit both buttons when complete, Both LEDs
should light, and you are done with these adjustment.
Now press the left button and the legs should lower; again this is fast and loud. The bike should
be held up firmly! Hit it again and the legs should retract. If you are satisfied with these limits,
you have successfully installed the LegUp System.
31