LegUp LandinGear Generation II Installation Manual page 38

Table of Contents

Advertisement

SEMI-AUTOMATIC DEPLOYMENT: Another way to deploy the legs is semi-automatically.
First we must be SURE that the proximity sensor is working properly or the wheels could come
down at higher speeds than we wish. If you are travelling at a speed over 10 MPH, AND the
yellow light (bottom) on the handlebar control is out, hit the left button. The bottom or yellow
LED should start to flash. When you slow down to around 5MPH the wheels will deploy (see
the red/green flash on top LED). Again prepare to put your feet down. IF the lower LED is lit at
a speed over 10 MPH, don't hit that button; see caution below!
NOTE: The bottom LED Should not be LIT SOLID if the bike is travelling over
10MPH! In the event it is, the wheels will deploy instantly if you try to set them as
above; this is dangerous! You MUST re-visit the sections on testing the proximity
sensor. You should always be aware that this light should NOT be on if you are
traveling at speed, and 'Arming' the system for deployment should only be
attempted if the lower LED is Not Lit! Please see the User Manual for more
information on Proximity Sensor Failure!
The next thing to try is to make a turn from a dead stop with the wheels down. As soon as you
start the bike moving, turns can only be made by using the handlebars. The LegUp system is too
strong to allow a great deal of lean with the wheels down! If you need to make a turn shortly
after departing from a stop, raise the wheels manually (left button) and you will get complete
control again.
The next thing to try is slow speed maneuvering with the wheels lowered. If you keep your
speed down, most slow speed maneuvers can be accomplished with your feet up, keeping in
mind that at about 6 MPH the wheels will come up automatically! You can try full lock turns in
both directions and the bike should stay upright with your feet up.
Understand; it is always a good idea to keep your feet near the ground during these maneuvers
if you can. A mechanical failure or a wheel in a pothole could upset the bike.
Because the wheels are right behind your legs when they are down, we recommend not trying to
push with your feet to move the bike forward. Use the engine and keep your feet out of the way;
this way the legs don't bite at your heels as the floorboard always have! Backing up using your
feet works fine and the chore of balancing the bike is taken care of for you.
Practice, practice, practice!! Enjoy your LegUp System!
38

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents