LegUp LandinGear Generation II Installation Manual page 24

INITIAL SYSTEM TEST
Turn your bike to Accessory Mode (counter clockwise on Road Kings, all the way right on
other models). Your speedometer should illuminate, and if everything is working properly, the
compressor should turn on for about 6 seconds to fill the onboard air tank. At this point, have a
look at the yellow proximity sensor.
PLEASE NOTE: Immediately after turning on your bike (within 5 seconds), the top light on
the handlebar control will flash for a few seconds. This is the system either making sure that
no air is in the legs if they are up (for safety it makes sure air does not build up when the legs
are in the up position), or that the proper amount of air is in the system if they are down
(again for safety to make sure the legs stay pumped completely!). This test occurs once a
minute for all the time the bike is powered up, whether you turn the LegUp system on or not!
The RED LED (ON The Sensor)
Should Not Be Lit. Take a metal object
(screwdriver, wrench, etc.) and hold it
on the flat face of the sensor (it has a
circle embossed in it). The LED should
light up, and go out when you move
the metal away. If not, check all your
connections.
Next, press the rightmost pushbutton
on the handlebar switchbox, and hold it
for at least 3 seconds. Both LEDs on
the switch panel should light up; green
means the legs are up and yellow
means the bike is traveling under 6MPH. If this occurs, you are doing well.
The next step requires some care. If the bike is still on the lift, have a helper hang on to it as you
touch the left button for just a split second. The legs should move down, likely until the wheels
hit or miss the lift, and they do this VERY quickly! The compressor will likely start and run for
about 10 seconds. Press the left button again and they should move up.
If all of the above has occurred, great! Turn the ignition switch off, the test is complete!
Let's move on to mounting the Proximity Sensor.
24