Running Air Lines - LegUp LandinGear Generation II Installation Manual

We need to route the air lines from the cylinders to the area near the left saddlebag. You should
the other line, away from anything that might
damage it!
At right we have a picture of the line running
under the right floorboard mount, tied lightly to
the floorboard mount (Notice Ben is extending
the leg, so he gets the needed slack from the
line) and run under the right side cover area to
get to the other side of the bike and joining the
left line. Get the line there any way you can,
just be sure that it is secure, and cannot be damaged by anything hot or moving. Once run, you
should mark the end with masking tape as 'RIGHT'.

RUNNING AIR LINES

find 2 long air lines of identical lengths. On the
right side of the bike, press one end into the
fitting on the back of the air cylinder. These press
in relatively easy, but a small tug will make sure
the line is seated.
Guide the line through the hole in the mount as
shown by the arrow at left (all styles have a hole
for the line); picture may not show your style
board. We now need to guide that line over to the
left side of the bike as we will be running it with
Take the other line; insert it into the left
cylinder as you did on the other side. Mark the
far end as 'LEFT' and tie the marked ends
together with masking tape, so we can run
them together.
Check Both Sides before we move on that by
lowering and raising the legs, there is plenty of
slack for the lines. Readjust your wire ties if
need be, but make sure they work properly to
avoid headaches later!
16