LegUp LandinGear Generation II Installation Manual page 17

We want to run the lines behind or through the
area under the left side cover. Here Ben ties the
two together on their way toward the back. We
want to guide these up to where the wire
running along the fender support is. We like to
tie two loose wire ties to that wire, and run the
air lines through them. We will adjust and
tighten everything a bit later.
The main concern here is to make sure the lines
are run where they will be safe from the belt,
exhaust pipes, or anything that could hurt them.
Here is a picture of the lines running along the bottom of the fender support, being tied off to
the big wire running toward the back. You can tie them to anything you like, as long as they are
safe and out of the way! Then you can start working back tying off the lines. Tighten the lines
easier to remove and install the bags. Just
take the lines as shown here, make a nice
loop, and tie them off to each other. Not too
tightly as we want the loop to be able to
move as you try to remove or install the bags.
Next we want to prepare the saddlebag. This
requires us to drill a few small holes to allow
lines or fittings to travel through the bag to
get to the compressor system.
under the fender strut, and just leave the end
wild for now!
These are air lines, so tie them off
snugly. Careful though; too tight could
restrict the air flow.
Once we have everything tied up, we want to
make a loop with the extra line. This will keep
the lines the same length (which allows the
wheels to come down evenly) and makes it
17