LegUp LandinGear Generation II Installation Manual page 27

need to do, you MUST make sure that as the wheel turns, the light works as described above!
Once you are certain, tighten the shock bolt and test it again! Rotate the wheel past all 5 spokes
on the brake rotor and make sure the light blinks and goes out each time. If all is perfect, you
are done! The automatic retraction of the legs as well as their deployment RELIES on this
sensor being placed perfectly! Now we can route the wire.
If this is not happening,
you may need to get the
sensor a bit closer to the
brake rotor (5MM is a
very small distance!). If
this is not happening, you
may need to get the
sensor a bit closer to the
brake rotor (5MM is a
very small distance!). If
you have to move the
sensor closer, you may
have to bend the bracket
just a tad (you may even
need to loosen or remove
it to bend it as you need
to). No matter what you
27