LegUp LandinGear Generation II Installation Manual page 12

Start by getting the wire with the 2 big plugs on it, run inside the left shock toward the back of
the bike. Next, measure 10 inches back from the 12 pin (biggest) plug and mark the wire. We
You can now pull the extra wire back into the under seat area. Later we will be securing air
lines to this wire, so make sure that will be possible with your choice of how to attach this wire!
The only wire left dangling should be the proximity sensor and mount, and we will handle that
soon.
are trying to make sure we have all the
wire we need but not too much extra.
Run the wire under the chrome fender
support and tie it off to the two fender
supports. 2009 and later bikes look like
the picture at left, on others it will look a
bit different; just make sure you leave
the wire needed, and tie it off securely
and out of the way of anything that
moves or could hurt the wire.
No Matter how you need to secure the
wire, make sure you have 10 inches of
wire sticking out from the end of the
fender support, to allow us enough wire
to get what we need into the saddlebag.
12