Handle - Bushranger MT2601 Operator's Manual

ASSEMBLY PROCEDURES
Handle Assembly
Fitting The Handle
1. Components - 4x Screws, Loop Handle & Clamp.
2. Place Handle (1) over the shaft in the desired location.
3. Insert Clamp (2) from the bottom side of the handle.
4. Insert screws (3) and washers (4) through loop handle and into threads of the clamp.
5. Tighten screws to lock handle into position.
CAUTION! Not too loose or too tight. Over tightening may damage the unit.
Fig. 1
Guard Assembly
Fitting The Straight Shaft Guard
1. Position the guard (3) by lining up the mounting holes on guard mount (2).
2. Secure the guard with two screws (1).
Fig. 2
8
4
1
3
1
3
2