Setting The Working Height - DURKOPP ADLER 171 Operating Manual

Set-up
Operating manual 171/173 Version 01.0 - 01/2016
6.6

Setting the working height

The working height can be adjusted continuously between
750 and 900 mm (clearance between the floor and upper
edge of the table plate).
Fig. 37: Setting the working height
①
(1) - Screws
1. Loosen all four screws (1) on the head sections.
2. Set the table plate to the desired height.
Important: Pull out or push in the table plate evenly at both
sides to prevent it from jamming.
3. Tighten the screws (1) on the head sections.
①
59