Advertisement
Kirby Morgan Dive Systems, Inc.
®
1430 Jason Way Santa Maria, California 93455
Phone: 805/928-7772
Fax: 805/928-0342
www.KirbyMorgan.com email: kmdsi@KirbyMorgan.com
NOTE: Adapter sleeves remain away from the shrouds until the bent tube is properly installed per helmet
manual guidelines. The adapter sleeves can be moved away from either end while securing each end of the
bent tube, however, they must remain on the bent tube.
15) Once the bent tube is secured and torqued to the correct values, insert the adapter sleeves into the pro-
spective locations, long adapter sleeve into the side block end and the short adaptor sleeve into the regula-
tor inlet side.
16) Line up the detail features of water tubes A & B, with the mating details of both adapter sleeves.
Water flow arrow is found on the A tube and should be positioned farthest away from the helmet (on the
outside)
Page 5 of 8
© ⅯⅯⅩⅧ Kirby Morgan Dive Systems, Inc. All Rights Reserved
Document # 180117001
Advertisement
