Advertisement
Kirby Morgan Dive Systems, Inc.
®
1430 Jason Way Santa Maria, California 93455
Phone: 805/928-7772
Fax: 805/928-0342
www.KirbyMorgan.com email: kmdsi@KirbyMorgan.com
8) Reinstall all of the side block parts that were removed except the bent tube assembly.
Regulator Shroud
9) Lightly lubricate the opening of the regulator shroud, 455 P/N 510-723, where the adjustment knob of
the regulator will pass through.
Notice the opening is surrounded by many fine slices to allow the shroud in that area, to eas ily spread over
the large end of the adjustment knob.
10) Starting at the adjustment knob end of the regulator, slip the regulator shroud over the adjustment
knob.
Page 3 of 8
© ⅯⅯⅩⅧ Kirby Morgan Dive Systems, Inc. All Rights Reserved
Document # 180117001
Advertisement
