Table of Contents
Advertisement
Auto Time Adjustment
You can configure watch settings to connect
with a phone at preset times each day and
adjust its time settings in accordance with
information obtained from an online time
server.
Using Auto Adjust
●
Your watch adjusts its time setting four times
a day according to a preset schedule. If you
leave your watch in the Timekeeping Mode, it
will perform the adjustment operation
automatically as you go about your daily life,
without any operation required by you.
Important!
The watch may not be able to perform
●
auto time adjustment under the
conditions described below.
While the watch is too far away from
ー
its paired phone
While communication is not possible
ー
due to radio interference, etc.
While the phone is updating its
ー
system
Note
If there is a World Time City specified
●
with G-SHOCK Connected, its time will
also be adjusted automatically.
The watch will connect with the phone
●
and perform auto time adjustment at
around 12:30 a.m., 6:30 a.m., 12:30
p.m. and 6:30 p.m. The connection is
automatically terminated after auto
time adjustment is complete.
Time signal auto receive will be
●
performed if there has been no auto
time adjustment based on connection
between the watch and phone for more
than one day.
Operation Guide 3459/3461
Triggering Immediate Time Adjustment
●
The watch's time setting will be adjusted
automatically whenever you establish a
connection between the watch and a phone.
Whenever you want to adjust the watch's time
setting based on your phone's time, perform
the procedure below to connect with a phone.
1.
Move the phone close to (within one meter
of) the watch.
2.
On the watch, enter the Timekeeping
Mode.
Navigating Between Modes
l
3.
Press (D).
[TIME] flashes to indicate that the watch
has started the connection operation.
Once the watch and phone are
connected, [OK] will appear, and then the
watch will adjust its time setting based on
information from the phone.
Trying to connect
Note
The connection is terminated
●
automatically after time adjustment is
complete.
If time adjustment fails for some
●
reason, [NG] or [ERR] will appear.
[RCVD] flashes when the receive
●
operation starts, and [RCVD] appears
after it is complete.
Configuring Reminder
Settings
After you use G-SHOCK Connected to create
a reminder for an appointment, anniversary, or
some other event you don't want to forget, the
watch will remind you when that day is
reached.
You can have up to five reminders
●
registered.
1.
Y Tap the "G-SHOCK Connected" icon.
2.
X Hold down (C) for about three seconds
until e and [CNCT] flash on the display.
When a connection is established
between the watch and phone, e and
[CNCT] will stop flashing.
If connection fails for some reason, [NG]
●
or [ERR] will appear on the display
momentarily and then the watch will
return to the Timekeeping Mode.
Following time
adjustment
Trying to connect
3.
Y Follow the instructions that appear on
the screen to configure reminder settings.
You can input up to 18 alphanumeric
●
characters as a reminder title.
Configuring World Time
Settings
Specifying a World Time City with G-SHOCK
Connected causes the watch's World Time
City to change accordingly. Watch settings
can be configured for auto summer time
switching for the World Time City.
Note
G-SHOCK Connected World Time lets
●
you select from among approximately
300 cities as the World Time City.
Connected
8
Hide quick links:
Advertisement
Table of Contents
