Measuring A Split Time; Timing The First And Second Place Finishers; Timer; Setting The Time - Casio 3461 User's Operation Manual

Measuring a Split Time

1.
Use the operations below to measure
elapsed time.
Each press of (D) causes the elapsed
●
time up to that point (split time) to be
indicated.
D
Start
A
Split
A
Split release
D
Stop
Elapsed time is shown in 1/100-second
●
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
First hour After first hour
Minutes, seconds, Hour, minute, second
1/100 seconds
2.
Press (A) to reset the elapsed time to all
zeros.
Operation Guide 3459/3461
Timing the First and Second
Place Finishers
1.
Use the operations below to measure
elapsed time.
* This displays the time of the first
finisher.
Elapsed time is shown in 1/100-second
●
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
First hour
Minutes, seconds,
1/100 seconds
2.
Press (A) to display the time of the second
finisher.
3.
Press (A) to reset the elapsed time to all
zeros.
D
Start
A
1st Finisher*
D
2nd Finisher*
After first hour
Hour, minute, second

Timer

The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper is muted in the cases described
●
below.
When battery power is low
ー
Getting Ready
Enter the Timer Mode.
Navigating Between Modes
l

Setting the Time

The countdown start time can be set in 1-
second units up to 24 hours.
1.
Hold down (A) for about two seconds.
This causes the hours digit to flash.
Hours
2.
Use (D) and (B) to change the timer hours
setting.
3.
Press (C).
This causes the minutes digits to flash.
Minutes
4.
Use (D) and (B) to change the timer
minutes setting.
5.
Press (C).
This causes the seconds digits to flash.
Seconds
6.
Use (D) and (B) to change the target time
seconds setting.
7.
Press (A) to exit the setting screen.
Note
You can also use G-SHOCK
●
Connected to configure timer settings.
14