About This Documentation; Validity Of The Documentation; Required And Additional Documentations; Presentation Of Information - Aventics Marex 3D Assembly Instructions Manual

4 AVENTICS | Marex 3D | R417003106–BDL–001–AA

About this documentation

1 About this documentation
1.1

Validity of the documentation

This documentation applies for the following products:
3D Controller, material No. 3460690410
These assembly instructions are intended for mechanics and
service technicians. They contain important information for
properly and safely installing and dismantling the
3D Controller.
The 3D Controller is a component of the Marex 3D ship
control system. Refer to the documentation on Marex 3D for
information on the start-up and operation.
Read these assembly instructions completely, especially the
chapter 2, Safety instructions, before installing or
dismantling the 3D Controller.
1.2

Required and additional documentations

Before starting the operation of the 3D Controller make sure
to read and understand the documents listed in table 1.
Table 1: Required and additional documentations
Title
Marex 3D
3D Tuning
Joystick Type 531
Contact Aventics Marine at marineservice@aventics.com or
www.marex-shipcontrols.com for further documents.
1.3

Presentation of information

Consistent symbols, terms and abbreviations are used in this
document and safety instructions are given in a consistent
Document No.
R417003094
R417003097
R417003072
Document Type
Instruction Manual
Software description
Assembly Instructions