Advertisement
Quick Links
*25073*
25073
Door Closer With Scanner Activated Hold Open
The LCN Sentronic HSA (Holder Scanner Activated) is a door closer with a scanner activated hold open feature designed to hold the door
open as long as there is traffic passing through the opening.
Packing
Nut
Spring
Power
Adjustment
Cover Screw
Packing
Arm Shaft Spacer
Nut
Spring
Power
Arm Shaft Screw
Adjustment
Cover Screw
Arm Shaft Spacer
Arm Shaft Screw
Customer Service
1-877-671-7011
www.allegion.com/us
4311 HSA
Cover
Cover
How To Tell Hand Of Door:
LH
How To Tell Hand Of Door:
Maximum
33 Ft/lbs
=
Opening
58 N-m
Torque
LH
Maximum
33 Ft/lbs
=
Opening
58 N-m
Torque
Arm
Track
Plugs (4)
Arm
Track
Plugs (4)
RH
Maximum
33 Ft/lbs
=
Opening
58 N-m
Torque
RH
Maximum
33 Ft/lbs
=
Opening
58 N-m
Torque
Scanner
Installation Instructions
Power Board
Mounting Bracket For
Surface Run Conduit
Hole For Concealed
Conduit
Scanner
Power Board
Mounting Bracket For
Surface Run Conduit
Hole For Concealed
Conduit
End Cap
Track
Roller
End Cap
Track
Roller
© Allegion 2016
Printed in U.S.A.
25073 Rev. 06/16-j
Advertisement
Related Manuals for Allegion LCN 4311 HSA
Summary of Contents for Allegion LCN 4311 HSA
- Page 1 How To Tell Hand Of Door: Maximum Maximum 33 Ft/lbs 33 Ft/lbs Opening Opening 58 N-m 58 N-m Torque Torque © Allegion 2016 Customer Service Printed in U.S.A. 25073 Rev. 06/16-j 1-877-671-7011 www.allegion.com/us Maximum Maximum 33 Ft/lbs 33 Ft/lbs Opening...
- Page 2 CAUTiOn Installation Instructions improper installation or regulation may result in personal injury or property damage. Follow all instructions WArning carefully. For questions, call LCn at 877 - 671 - 7011 Closing Speed regulation is preset at factory. HAZArDOUS VOLTAgE CAn SHOCK AnD CAUSE SEVErE inJUrY Normally no adjustment is required, if desired: adjust Main and Latch Speed by turning proper regulating Disconnect power before making any electrical connections...
- Page 3 Figure 1 Spring Power Adjustment & Closing Speed Regulation Figure 1 Spring Power Adjustment & Closing Speed Regulation Figure 1 Spring Power Adjustment & Closing Speed Regulation Increase Force Increase Increase Force Force Spring Adjustment Spring Spring Adjustment Adjustment Decrease Force Decrease Decrease...
- Page 4 Cover Alignment Tab Set dip switch 1 to ON to increase sensitivty. Mask Electrical Checkout L After completion of installation & wiring, and with the unit properly powered, perform the following steps: When 24V AC-DC power is applied, LED on scanner will flash on and off for 10 seconds, then turn off.
Need help?
Do you have a question about the LCN 4311 HSA and is the answer not in the manual?
Questions and answers