Extron electronics HC 403 EU Setup Manual page 11

Step 9 — Mount the HCT 102 EU or HCT 102 MK
Before mounting the transmitter, make sure that all device cables have been fed through the wall frame and are connected to the
rear panel.
To mount the transmitter (see figures 9 and 10):
Disconnect power at the source from all devices in the system.
1.
Align the mounting holes in the transmitter with
2.
those in the mounting plate. (The mounting plate
was attached to the wall box in
Site preparation on page 6.)
Wall Box
Mounting Plate
Mounting the
Figure 9.
HCT 102 EU Transmitter to an EU Wall Box
Secure the transmitter to the mounting plate as follows:
3.
Insert the included screws through the mounting holes at the top and bottom of the transmitter and into the
a.
corresponding threaded holes in the mounting plate.
Using a Phillips screwdriver, lightly tighten the screws until snug.
b.
Reconnect power to all devices.
4.
Wall Box
A IN
T O
A U
V G
V G A
M I
H D
C P
H D
R
P W
IN
D IO
A U
IN
M I
H D
T 1
H C
IN
D IO
A U
Extron
HCT 102 EU
Mounting Plate
E U
0 2
Figure 10. Mounting the HCT 102 D
Transmitter to an MK Wall Box
T O A IN
A U
V G
A
V G
M I
H D
C P
H D
R
P W
IN
D IO
A U
IN
M I
H D
H C
IN
D IO
A U
Extron
HCT 102 MK
M K
0 2
T 1
11