Front And Side Panel Features - Extron electronics HC 403 EU Setup Manual

Panels and Features

Front and Side Panel Features

HCT 102 MK Front
Input
3
HCR 102
R
CONFIG
I J A
Figure 2. HCT 102 MK Front Panel (Top), HCR 102 Front Panel (Bottom),
A Configuration (Config) connector
B Input selection button and
C Input signal presence (Signal)
D Input HDCP status LED, page 16
E Audio input type LEDs
F
Menu button,
G Enter button, and
H
Navigation (right , left , up , and down  arrow)
To configure the AV settings using the OSD
buttons (see
and front panel buttons:
J Reset button (HCR 102) — Pressing this recessed button causes various product settings to be reset to the factory defaults
(see Reset Modes: a Brief Summary
I Reset and power LED— This green LED indicates either the power status of the transmitter or the receiver, or the reset
mode of the receiver. LED indications are as follows:
HCT 102 EU/MK Transmitter
• Off — The unit is not powered on.
• On, lit green — The unit is
powered on.
K Auto Switch LED — This LED on the transmitter lights green if either of the auto-switching modes is enabled, and it turns off
if both of the auto-switch modes are disabled. For details on auto-switching modes, see the HC 400 Series User Guide.
I D C K
PWR HDCP HDMI VGA AUTO
HDMI IN
AUDIO IN AUDIO IN
C
INPUT
SIGNAL
1
HDCP
B D
(USB mini-B), page 13
LED, page 16
LEDs, page 16
(LPCM-2Ch and Multi-Ch, page 16
on page 9)
on page 17).
HCR 102 Receiver
• Off — The unit is not powered on.
• On, lit steadily — The unit is powered on.
• Blinking — The unit is powering up or the HCR 102 is performing a reset.
The blink pattern depends on the selected reset mode.
For full descriptions of reset modes, how to use the reset button to activate them,
and details of LED indications of each mode, see the HC 400 Series User Guide.
VGA IN
Input
HCT 102 MK
MENU
AUDIO
1
LPCM-2CH
MULTI-CH
ENTER
E FG
I
Power LED (HCT 102 EU/MK), power and reset indicator
LED (HCR 102) (see below)
J Reset button (see below and page 17)
K Auto Switch LED (see below)
L
Service connector (for use by Extron support staff)
NOTES:
• The EU and MK transmitters are identical except for
faceplate size and mounting hardware. They have the
same connectors, LEDs, and capabilities.
• For AV connectors on the HCT 102 EU/MK, see
Side, and Front Panel Features
HCT 102 MK Side
L
RESET
2
SERVICE
HOLD FOR 720p/1080p
HCR 102
H
on page 4.
Rear,
3