Table of Contents
Advertisement
By default the station filter is switched off. This may result in data overflows at
the output if you take the cassette in operation without corresponding settings.
Customize the station filters accordingly!
Channel as well as frequency setting is possible for modulators.
The QAM modulated RF output signals are sent through the RF output of the
cassette to the output collector. The common output level of the channel strips
can be set at the output collector.
The control of the cassette takes place via the control unit of the head-end station.
When the head-end station is switched on, the two-line LC display shows the
software version of the control unit. To operate this cassette the software ver-
sion of the control unit must be "V 45" or higher. You can find the current op-
erating software for the control unit and the cassette, the software "BE-Flash"
and the current assembly instructions on the website "www.triax.com".
The cassette is intended for use in CSE 3300 head-end systems.
When using these cassettes in Stations with more than eight slots, a maximum
of 8 cassettes may be operated, to prevent overloading the power supply and
overheating the head-end station.
All other slots must remain free!
2.5 s
o f t wa r e
Control unit
If necessary, you can activate the indication of the software version of the
control unit manually:
• Press any two keys on the control unit of the head-end station simultaneously
until the display goes dark and the software version, e.g. "V 45" appears.
Cassette
The software version of the cassette is shown in the display after activating the
cassette (see page 18).
q u e ry
- 7 -
CC2CT 800 C
Advertisement
Table of Contents
