Station Filter – Selection - Triax CC2CT 800 C Assembly Instruction Manual

i
n P u t
In this menu you set the input channel / input frequency of the transponder you
would like to receive.
• Use buttons
resp. channel displayed to be set.
• Press buttons
• Press the
/
C h a n n e l f r e q u e n C y
to position the cursor under the digit of the frequency
to set the desired channel/frequency.
—> Once the RF receiver has synchronised to the input signal, "OK" is
displayed.
—> If "– –" appears in the second line of the display, there is no input
signal present. Check the configuration of the antenna system and
the head-end station as well as the preceding settings of the module.
—> The quality of the received transport stream is indicated by a status
LED:
LED indicator
Green
Yellow
Red
Blinking
red/green
Off
button.
—> The "Station filter – Selection" – e.g. "01/04" submenu is activated.
Bx 4A/B FREQ
C55 746.00 OK
Signal quality is insufficient
Data overflow of the output data rate
The channel strip (modulator) is switched off
- 24 -
Indication
Signal quality is good
No signal
CC2CT 800 C