Mitsubishi Electric FX5-ENET User Manual page 34

*1 When the parameter is written without the IP address setting (blank), the following address is set.
192.168.3.251
Operational Setting
Set the destination alive check conditions for socket communication.
Item
Timer Settings Change/Set Timer Value
for Data
Communication
Destination Alive Check
Start Interval Timer
Destination Alive Check
Interval Timer
Destination Alive Check
Resend Count
CC-Link IEF Basic Setting
Set the CC-Link IE Field Network Basic.
Item
Network Configuration Settings
Refresh Settings
Station-based Block Data Assurance
■Network Configuration Settings
Set the network configuration.
Double-click <Detailed Setting> of the "Network Configuration Settings".
Item
[Detect Now] button
[Link Scan Setting] button
Connected Count
No.
Model Name
STA#
Station Type
7 PARAMETER SETTINGS
32
7.3 Basic Setting
Description
Select whether to change timer values from the default.
The timer operates with its default value when "No" is selected.
Set the time interval between the reception of the last message from the
external device and the start of alive check.
Set the time interval for performing alive check again when no response is
returned from the external device of alive check target.
Set the number of times to perform alive check when no response is
returned from the external device of alive check target.
Description
Set the information of the slave station to the master station. Moreover,
configure link scan settings (timeout time and number of retries for slave
station disconnection detection). (Page 32)
Configure the settings to automatically link refresh RX/RY/RWr/RWw data
to the devices. (Page 36)
Set whether to assure the data in station units when refreshing the link
between the host station and CPU module. This prevents the data that is
read/written for each slave is not separated into the new data and old data.
Description
Connected devices are automatically detected.
Configure link scan settings.
The total number of connected slave stations is displayed.
The station number of the slave station is displayed.
Module model name is displayed.
When there is no module information, "Module With No Profile Found" is
displayed.
The start station number of the slave station is displayed.
The station type (master station/slave station) is displayed.
Setting range
• No
• Yes
(Default: No)
• Unit [s]: 1 to 16383
• Unit [ms]: 100 to 16383000
(Default: 600 s)
• Unit [s]: 1 to 16383
• Unit [ms]: 100 to 16383000
(Default: 10 s)
1 to 32767
(Default: 3 Times)
Setting range


• Enable
• Disable
(Default: Disable)
Setting range






