Additional Support Information - Binary B-900-MOIP-4K-CTRL Networking Manual

3. Verify Jumbo Frame
Choose SETTINGS >
default value is 9216 the maximum is acceptable.

ADDITIONAL SUPPORT INFORMATION

• Each transmitter and receiver can be connected to the MoIP switch with up to 328ft / 100m
of category cable.
• CAT5e cabling is sufficient to support the MoIP system; however, with all networking installs
utilizing shielded CAT5e, CAT6, CAT6A or CAT7 is recommended to minimize potential for
interference from environmental factors.
• Each category cable should be terminated to the T-568B specification. TIA/EIA Standard
568-B (Gold Pins Facing Up)
Two (2) Year Limited Warranty
This Binary product has a Two-Year Limited Warranty. This warranty includes parts and labor
repairs on all components found to be defective in material or workmanship under normal
conditions of use. This warranty shall not apply to products that have been abused, modified or
disassembled. Products to be repaired under this warranty must be returned to a designated
service center with an assigned return authorization number (RA). Contact technical support
for an RA number.
SUPPORT
Need Help? Contact Tech Support!
If you need further clarification, please call tech support at 866.838.5052, or email
support@snapav.com. For other information, instructional videos, support documentation, or
ideas, visit our website and view your item's product page at
www.snapav.com.
PORTS, then verify
TIA/EIA Standard 568-B (Gold Pins Facing Up)
Pin 1 White/Orange
Pin 2 Orange
Pin 3 White/Green
Pin 4 Blue
Rev: 180710-1030
© 2018 Binary
Jumbo Frame is set to greater than 8,000 Bytes. The
Pin 5 White/Blue
Pin 6 Green
Pin 7 White/Brown
Pin 8 Brown