Binary B-900-MOIP-4K-CTRL Networking Manual
Hide thumbs
Also See for B-900-MOIP-4K-CTRL:
- Installation & setup manual (21 pages) ,
- Installation & setup manual (30 pages) ,
- Installation & setup manual (25 pages)
Related Manuals for Binary B-900-MOIP-4K-CTRL
Summary of Contents for Binary B-900-MOIP-4K-CTRL
- Page 1 MEDIA OVER IP SYSTEM B-900-MOIP-4K-CTRL B-900-MOIP-4K-TX B-900-MOIP-4K-RX NETWORKING GUIDE Source | M (HDMI Ou...
-
Page 3: Recommended Network Switches
This guide details the networking requirements, recommendations and limitations when configuring a Binary B-900 Series Media over IP system (MoIP) system which can be used to deploy MoIP on any compatible network switch. Also, you will find the simple steps to configure... -
Page 4: Number Of Ports
LAN as MoIP as a best practice. This is not required; however, highly recommended. Number of Ports Given the flexibility and scalability of Binary’s B-900 Series Media over IP system, it is recommended that a switch with more Ethernet ports than needed for the MoIP system be used to allow quick addition of devices in the future. -
Page 5: Multiple Switches
MoIP System Network Setups Single switch MoIP network configurations are supported by Araknis 210 PoE and 310 PoE Series switches. Integrators familiar with the above requirements and the configuration of stackable and cascaded switches with multi-gigabit uplinks will be able to create very large MoIP deployments. - Page 6 have no impact on available bandwidth. The bandwidth requirements of other devices on the network should also be considered. Each MoIP Transmitter will consume 250-850 Mbps (4K) or 150-750 Mbps (1080p) of the available bandwidth. The lowest bandwidth link limitation applies no matter to which switch in the multiple switch setup the transmitter is connected.
-
Page 7: Enable Igmp Snooping
ARAKNIS 210/310 PoE SERIES CONFIGURATION 1. Configure Network Switch Steps below use an Araknis 210 PoE or 310 PoE Series switch as an example 1. Factory default the MoIP switch to be used for all MoIP Components (not necessary for new switches). -
Page 8: Additional Support Information
Pin 8 Brown Two (2) Year Limited Warranty This Binary product has a Two-Year Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to products that have been abused, modified or disassembled.