Binary B-900-MOIP-4K-CTRL Networking Manual page 6

have no impact on available bandwidth. The bandwidth requirements of other devices on the
network should also be considered.
Each MoIP Transmitter will consume 250-850 Mbps (4K) or 150-750 Mbps (1080p) of
the available bandwidth. The lowest bandwidth link limitation applies no matter to which
switch in the multiple switch setup the transmitter is connected. To calculate the required
bandwidth needed to support the desired number of MoIP Transmitters, multiply the number
of MoIP Transmitters by 0.85. This will give you the bandwidth in Gbps. For example, 10 MoIP
transmitters would require 8.5 Gbps. In the diagrams below,
connection between switches. The throughput of this uplink must accommodate, for this
example, 8.5 Gbps for the MoIP system to operate optimally.
Cascaded Switches
MoIP Transmitter
MoIP Receiver
MoIP Transmitter
MoIP Receiver
Network
+5VDC
MoIP Controller
Stacked Switches
MoIP Transmitter
MoIP Receiver
MoIP Transmitter
MoIP Receiver
Network
+5VDC
MoIP Controller
X Gbps
MoIP Extended Switch
9 11 13 15
10 12 14 16
xGbps xGbps
MoIP Core Switch
9 11 13 15
10 12 14 16
MoIP Switch 1
9 11 13 15
10 12 14 16
X Gbps
MoIP Core Switch
9 11 13 15
10 12 14 16
6
indicates a multiple gigabit
To other network device
Main LAN Switch
9 11 13 15
10 12 14 16
To other network device
To other network device
MoIP Core
Switch Stack
Main LAN Switch
9 11 13 15
10 12 14 16
To other network device