Enable Igmp Snooping - Binary B-900-MOIP-4K-CTRL Networking Manual

ARAKNIS 210/310 PoE SERIES CONFIGURATION
1. Configure Network Switch
Steps below use an Araknis 210 PoE or 310 PoE Series switch as an example
1. Factory default the
new switches). Press and hold the reset button for 10—15 seconds until the Status LED
flashes once. This will reboot the switch and reset to factory settings.
2. Connect the dedicated MoIP switch directly to your
switch is the main network switch into which all other switches and network devices are
connected. The Main LAN switch is the only switch connected to the router. A dedicated
MoIP switch is preferred but not required. See 'Network Guide' for more information.)
3. Access the local of the
Note: Default login in credentials for an Araknis which are araknis / araknis. The Default IP
address is 192.168.20.254.

2. Enable IGMP Snooping

Choose ADVANCED > MULTICAST > IGMP
Enabled
1. Status:
2. Version: V2
3. Report Suppression:
4. Unregistered IPMC Forward Action:
5. IGMP Snooping Status:
6. Fast Leave: Enabled
7. Querier State:
8. Querier Version:
9. Router Settings > Router Ports Auto-Learned:
Apply
Click to save these settings
MoIP switch to be used for all MoIP Components (not necessary for
MoIP Switch.
Enabled
Enabled
Enabled
V2
Main LAN
SNOOPING, then check options as follows:
Flood
Enabled
7
switch. (The Main LAN