Sommaire Des Informations De Sécurité - Siemens MD-BMS User Manual

Building Technologies
WARNING
Sensor Limitations
Use only shunted Current Transformers (CTs).
Do not use other CTs. Only use shunted CTs with a 333 mV maximum output.
Serious shock hazard and logger damage can occur if unshunted CTs are used. The
UL listing covers the use of the following Siemens CTs that are UL Recognized and
have been evaluated to IEC 61010-1: SCT-HSC-0050-U (50A Mini), SCT-HMC-0100-
U (100A Midi), SCT-HMC-0200-U (200A Midi),
SCT-RXX-A4-U (Rogowski Coil), SCT-SRS-xxx, SCT-SRL-xxx, and SCT-RGT12-xxx.
NOTE:
Equipment protected throughout by double insulation (IEC 536 Class II).
CAUTION
PS Pulse output
30V maximum open voltage, 5 mA maximum current.
FCC COMPLIANCE
These devices have been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at user's own
expense.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Sommaire des informations de sécurité
Ces informations de sécurité sont destinées à être utilisées à la fois par l'opérateur de
l'enregistreur et le personnel de service. Siemens Industry, Inc. n'assume aucune
responsabilité en cas non-respect des directives en matière de sécurité par l'utilisateur.
The MD Power Meter est un appareil protégé contre les surtensions de catégorie III.
Conforme à UL Std 61010-1
IEC 6106-2-030
Certifié CSA Std C22.2 No. 61010-1
Introduction
Safety Summary and Specifications
11
125-202
06/06/2017