Problem
Bucket cutting edge wear is
uneven side to side
Bucket cutting edge wear
rate is excessive. (Wear rate
is even across full width of
bucket).
Note: Extensive use of bucket
on concrete or asphalt sur-
faces will accelerate wear
rate of bucket cutting edge.
KL135-10.indd 7
Possible Cause
Bucket is not level to ground.
Incorrect operational practices. Excessive
down pressure placed on bucket when being
used on hard abrasive surfaces.
Bucket wear pads worn.
TROUBLESHOOTING 10-
Correction
Check rear tire inflation and adjust to level
bucket to ground.
Refer to operation-scraping section for correct
operating procedures. Utilize float position.
Replace wear pads.
2013-02-01 오전 11:26:49