Table of Contents
Advertisement
ADSL2+ Tester
•
Protocol Overview
RFC1483 describes two different methods for carrying connectionless network inter-
connect traffic over an ATM network: routed protocol data units (PDUs) and bridged
PDUs.
Bridged Ethernet over ATM (RFC 1483B) performs higher−layer protocol multiplexing
implicitly by ATM virtual circuits. For more information, refer to RFC1483.
The base protocol is defined in RFC 1483B.
•
Page 1 of the "WAN PING" settings menu (BRIDGE)
In Page 1, set "Protocol" as BRIDGE, as shown in Fig 12. And press "Cursor
Moveable Right and Down" key to move the cursor to the positions of "DST" and
"IP ADDR Mode". And then you can use "F1", "F2", "F3" and "F4" softkeys to select
the parameters.
All the setting parameters of "DST" are shown in Table 6.
All the setting parameters of "IP Addr Mode" are shown in Table 10.
Item
Option
STATIC
IP
ADDRESS
DHCP
MODE
Table 10: "IP Addr Mode" configuration descriptions
S ett in g s
F un ct ion
D ST
D N S
P rot oc ol
IP ADDR M od e
i
Fig 12: Page 1 of "WAN PING" settings menu (BRIDGE)
•
Page 2 of the "WAN PING" settings menu (BRIDGE)
72-0046-03A
IP address is known.
Dynamic Host Configuration Protocol, DHCP's purpose is to
enable individual computers on an IP network to extract their
configurations from a server (the "DHCP server") or servers,
in particular, servers that have no exact information about the
individual computers until they request the information.
P : 1 / 2
[ P ING ]
[ IP ]
Conn e ct ing ......
P PPO E
P PPO A
Description
1 0 :3 0 : 00
[ WAN P ING ]
[ 2 0 2 . 0 9 6 . 1 3 1 . 0 0 7 ]
[ 2 0 2. 0 9 6. 1 3 4. 1 3 3 ]
[BR
IDGE]
[STAT IC ]
BR I DGE
> >
4 Navigating the Displays
35
Advertisement
Table of Contents
