Table of Contents
Advertisement
ADSL2+ Tester
"PING" testing includes
corresponding parameters should be set as described below in detail.
4.2.4
"LAN PING" settings menu
After selecting
"PIN
setting pages in this mode, as shown in Fig 8.
a. Page 1 of "LAN PING" settings menu
In Fig 8, press "Cursor Moveable Right and Down" key to move the cursor to the
positions of "DST IP", "LAN IP" and "IP MASK", and then you can use "F1", "F2", "F3"
and "F4" keys to choose the parameters.
All the setting parameters of above items are shown in Table 6.
Item
DST IP
LAN (WAN) IP
IP MASK
Table 6: Setting parameters in Page 1 of "LAN PING"
You can edit address by selecting
the last 6 recent used IP address.
Caution:
You should ask the administrator for the detailed information about the
destination IP address, LAN or WAN IP address and subnet mask.
b. Page 2 of "LAN PING" settings menu
Press "PgDn" key to go to Page 2, as shown in Fig 9. In Page 2, press "Cursor Movable
Right and Down" key to move the cursor to the position of "Writing Config". And then
you can use "F1" to choose YES. And then all the setting configurations will be written
into the tester and become effective.
Any change of setting to the parameters of "DST IP", "LAN IP" and "IP
MASK" should be re-configured by set "WRITING CONFIG" as YES. Only
after writing the configurations into the tester firstly can make the new
settings effective. If the IP address input is available, "write success" will be
displayed on the LCD. If the IP address input is invalid, "write fail" will be
displayed on the LCD.
Any change to "Packet Length" does not need reconfiguration.
72-0046-03A
LAN PIN G
and
G" test function, set the PING type as
Range of IP Address
Destination IP address:
000.000.000.000~255.255.255.255
LAN (WAN) IP address:
000.000.000.000~255.255.255.255
Subnet Mask:
000.000.000.000~255.255.255.255
EDIT
WAN PING
. In these two testing modes,
"LAN P IN
to input a new IP address or
4 Navigating the Displays
G". There are two
Option
EDIT
RECENT
EDIT
RECENT
EDIT
RECENT
R EC ENT
to input
30
Advertisement
Table of Contents
