3.7
Installation of the stylus pen holder
The stylus pen offered is used to operate the touch screen of the OER-Elite.
Required items
Check
Table 3.1
Installing the stylus pen holder
1
Align the two holes on the stylus pen holder
with the screw holes on the right side panel of
the equipment and secure it with two M4 ×
10 mm cap bolts using the provided hex
wrench.
2
Place the stylus pen in to the stylus holder.
OER-Elite INSTALLATION MANUAL
M4 × 10 mm cap bolt
Hex wrench (GT804300)
Stylus pen holder (RA016500)
Stylus pen (GT944200)
3.7 Installation of the stylus pen holder
Required items
Figure 3.6
Ch.3
43