HMS Anybus Wireless Bridge II Startup Manual page 24

This document does not include complete instructions for the safe use of the described equipment. Make sure that
you have read and understood the original user documentation for the equipment before proceeding.
Anybus ®
Additional certification and compliance information
ATEX
Anybus Wireless Bridge II modules are certified for use in potentially explosive atmospheres in compliance
with the following standards:
• EN 60079-0: 2012 + A11:2013
• EN 60079-15: 2010
The certification number of the Anybus Wireless Bridge II certified modules according to the ATEX directive
2014/34/EU is:
• DEMKO-17ATEX1895X
According to the two standards listed above, the Anybus Wireless Bridge II modules are certified with the
following marking:
The above marking indicates that Anybus Wireless Bridge II modules are certified as electrical equipment
of:
• equipment group "II" : intended for use in areas with explosive gas atmosphere other than mines
susceptible to firedamp.
• category "3 G": intended for use in zone 2 hazardous areas, in which explosive atmospheres caused
by mixtures of air and gases, vapors or mists are present between 1 and 10 hrs/yr.
• level of protection "nA": non-sparking (for Equipment Protection Level Gc)
• subdivision 'IIC': intended for use in areas where the nature of the explosive gas atmosphere is
considered very dangerous based on the Maximum Experimental Safe Gap or the Minimum Ignition
Current ratio of the explosive gas atmosphere in which the equipment may be installed (a typical gas is
hydrogen), so that the modules are also suitable for applications intended for use in subdivision IIB
(typical gas is ethylene) and subdivision IIA (a typical gas is propane). Gas group IIC is the most
stringent group and covers also groups IIB and IIA.
• temperature class "T4": The maximum surface temperature determined shall not exceed 135 °C
© 2018 HMS Industrial Networks AB
Wireless Bridge II
COMPLIANCE SHEET
™
SCM-1202-066 EN 1.3 / 2018-05-09 / 8539