Table of Contents
Advertisement
8.1 ConVerSion enD CapS kit MoUntinG
Front hub
Remove the end-caps installed on the front hub (standard TA 12x100 mm)
and replace them with required ones (QR 100 mm, TA 15 mm).
Install the end-cap with the smaller flange diameter (1) on the disc brake rotor
side and the one with the bigger flange diameter (2) on the opposite side.
Make sure the washer (3) is correctly positioned in the end-cap seat (4) before
inserting caps into the hub.
(1)
(3)
(4)
Rear hub
Unscrew the end-caps fastened to the rear hub axle (standard TA 12x142
mm) with appropriate wrenches and replace them with the required one (QR
135 mm).
Install the longer end-cap (1) on the disc brake rotor side and the shorter one
(2) on the opposite side (drive side).
Make sure the washer (3) is correctly positioned in the end-cap seat (4) before
inserting caps into the hub.
(1)
(3)
(4)
(3)
(2)
(4)
(3)
(2)
(4)
21
Advertisement
Table of Contents
