Printing A Network Configuration Page - Samsung CLP-510 Series Setup Manual

Printing a Network Configuration Page

The Network Configuration page shows how the network
interface card on your printer is configured. The default settings
which are suitable for most applications are enabled.
1
In ready mode, press the Menu button (
"Network" on the bottom line of the display.
2
Press the Enter button (
3
Press the scroll button (
displays on the bottom line.
4
Press the Enter button (
The Network Configuration page prints out.
Setting Network Protocols
When you first install the printer, all supported network protocols
are enabled. If a network protocol is enabled, the printer may
actively transmit on the network even when the protocol is not in
use. This may increase network traffic slightly. To eliminate
unnecessary traffic, you can disable unused protocols.
1
In ready mode, press the Menu button (
"Network" on the bottom line of the display. Press the Enter
button ( ) to access the menu.
2
Press the Enter button (
displays on the bottom line.
3
Press the scroll button (
press the Enter button (
button ( ).
4
Press the scroll button (
protocol on the bottom line.
You can choose between "Config TCP" and "Netware".
5
Press the Enter button (
6
Press the scroll button (
If you selected "Config TCP", change the setting to "No"
(disable) or "Yes" (enable).
If you selected 'Netware', change the setting to "Off"
(disable) or "On" (enable).
7
Press the Enter button (
8
Press the On Line/Continue button (
ready mode.
) to access the menu.
or ) until "Print Net CFG"
).
) when "Config Network"
or ) until "Yes" displays, and
). Then press the Upper Level
or ) until you see the desired
).
or ) to change the setting.
) to save the selection.
) to return to
U Y P
SING OUR RINTER ON A
) until you see
) until you see
C.7
N
ETWORK
C