Z522 - Ranger boats Z-Comanche Owner's/Operator's Manual

Wake and Sleep Mode
Sleep mode will cause the keypad to reduce power consumption by reducing live circuits. For the keypad to
enter the sleep mode, it will require the main 30 amp breaker to be on and no switch activity for four hours, all
pumps turned off and the ignition is off. When the key pad is in the sleep mode, the accessories will not function.
To wake the keypad, you must press one of the following functions: Start, Stop, 1, 2, 3, 4 or any button on the bow
touch pad with the main breaker set to the on position. After pressing one of the buttons, you can then proceed
with your desired operation. While the keypad is in the sleep mode, the float switch to the bilge still has power and
if the float switch is triggered, it will wake the keypad. If the bilge pumps, livewell pumps, or ignition is left on, the
system will not enter sleep mode.
Keyless Ignition
Starting the engine:
• Turn the main breaker to on.
• Press on the buttons required to wake the system.
• Enter the following user code unless it has not been changed in order "1-2-3-4".
• Press "Start". After pressing start the LED by the stop button will light putting the keyless ignition switch in
accessory mode.
• Press the "Start" button a second time holding it for two seconds and the engine will crank.
• Once the engine has started, release the "Start" button.
• To stop the engine, press the stop button.
• To lock the system after stopping the engine, enter the user code "1-2-3-4" and then press "Stop".
To choke a carbureted engine:
Press the "Start" and the "1" key simultaneously while starting the engine.
To change the user code:
Wake the system up by pressing one of the buttons described above. Enter in the current user code followed
by pressing the "1" and "4" buttons at the same time. You will have two seconds after entering in the user code to
press the "1" and "4" buttons.
"1-2-3-4" buttons
Leave the "1" and "4" depressed until the stop LED flashes. If the stop LED does not flash after holding the "1"
and "4" down for five seconds, one of the following may have happened: the user code was not entered correctly
or "1" and "4" was not depressed at the same time, or too much time elapsed after entering in the user code before
pressing the "1" and "4" . Turn the system off by entering in the code and press stop, after the LED is not lit by the
stop button. Start at the beginning of this section again.
After the flashing of the stop LED is obtained, enter in the new four digit number followed by the start button,
and then re-enter the four digit number followed by the start button.
"X-X-X-X"
After pressing the start button the second time, the system will go into accessory mode. If it does not enter
accessory mode, type the current user code in and press the stop button, then proceed to the beginning of this
section.
Navigation Lights
The switch labeled "Nav./Anchor" on the bow and console keypads controls the operation of the navigation
lights. On the first key press, the bow navigation and stern anchor lights will turn on. On the second press, the bow
lights will turn off and the anchor light will remain on. On the third key press, the anchor light will turn off.
Electrical Systems
"1" and "4"
"Start" "X-X-X-X"

Z522

"Start"
59